СвязьПроект

Только не бейте сразу.
В общем суть такова! Есть IP АТС 3CX её ip 192.168.1.3 есть шлюз AD200D ip 192.168.1.7 их собственно надо подружить. все перечитал нифИГА ПОНЯТЬ НЕМОГУ..
в ОБЩЕМ КОНФИГ ВОТ..
show interfaces
Command base-URL: /exec/show/interfaces User ID: root

--------------------------------------------------------------------------------

Interface : ether0.0
IP Address : 192.168.1.7 Physical Interface : Ethernet0
Network : 192.168.1.0 Subnet Mask : 255.255.255.0
Administrator Status : UP Operation Status : UP
Network Type : Ethernet MTU : 1500
Hardware Address : 00 02 a4 07 1d c8

Ethernet0 is UP, Line protocol is UP
QoS control is disabled
interface type is 10Base-T
link status is 10 Mbps (HALF-DUPLEX)
last 1 minute data rate : tx 6976 bps, rx 2352 bps
405 packets input, 71646 bytes, 0 no buffers
Received 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
376 packets output, 94169 bytes, 0 drops
6 output errors, 0 collision, 0 interface resets
0 underruns, 0 late collisions, 6 deferred
0 lost carrier, 0 no carrier

Interface : ether1.0
IP Address : no ip address Physical Interface : Ethernet1
Administrator Status : UP Operation Status : DOWN
Network Type : Ethernet MTU : 1500
Hardware Address : 00 02 a4 07 1d c9

Ethernet1 is DOWN, Line protocol is DOWN
QoS control is disabled
interface type is 10Base-T
link status is 10 Mbps (HALF-DUPLEX)
last 1 minute data rate : tx 0 bps, rx 0 bps
0 packets input, 0 bytes, 0 no buffers
Received 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 drops
0 output errors, 0 collision, 0 interface resets
0 underruns, 0 late collisions, 0 deferred
0 lost carrier, 0 no carrier


Собственно говоря Interface : ether1.0 вообще неиспользуется да он пока и ненужен..

Command base-URL: /exec/show/version User ID: root
--------------------------------------------------------------------------------


VoiceFinder Gateway Series (AP200D)
Serial Number:
32BIT RISC Processor With 16777216 Bytes System Memory
8388608 Bytes System Flash Memory
2097152 Bytes 2nd System Flash Memory

1 RS232 Serial Console Interface
2 Ethernet/IEEE 802.3 Interface

AP200D System software Revision 8.30U
Released at Wed May 28 17:31:54 2008
Program is 1692660 bytes, checksum is 0xd8b3674
Едем далее..


Command base-URL: /exec/show/configuration User ID: root

--------------------------------------------------------------------------------

Using 2262 out of 65248 bytes
!
version 8.30U
!
hostname AP200
!
!
no bridge spanning-tree
!
dhcp-list 0 type server
dhcp-list 0 address server interface ether0.0
dhcp-list 0 option dhcp-lease-time 7200
!
dhcp-list 1 type server
dhcp-list 1 address server 10.1.1.2 10.1.1.254 255.255.255.0
dhcp-list 1 option dhcp-lease-time 600
!
!
ip-share enable
ip-share interface net-side ether0.0
ip-share interface local-side ether1.0
!
interface ether0.0
ip address 192.168.1.7 255.255.255.0
!
interface ether1.0
no ip address
ip dhcp-group 0
!
snmp name AP200D
!
no arp reset
!
route 0.0.0.0 0.0.0.0 192.168.1.1
!
auto-script autorun.inf
!
!
!
!
!
! VoIP configuration.
!
!
! Voice service voip configuration.
!
voice service voip
fax protocol t38 redundancy 0
fax rate 9600
h323 call start fast
h323 call tunnel enable
busyout monitor gatekeeper
busyout monitor voip-interface
display send e164
!
!
! Voice port configuration.
!
! FXO
voice-port 0/0
connection plar 222
ring detect-timeout 70
caller-id enable
!
!
! FXO
voice-port 0/1
no caller-id enable
!
!
!
!
! Pots peer configuration.
!
dial-peer voice 0 pots
destination-pattern 222
port 0/0
!
dial-peer voice 10 pots
destination-pattern 222
port 0/0
!
!
!
! Voip peer configuration.
!
dial-peer voice 100 voip
destination-pattern 222
session target 192.168.1.3
no vad
dtmf-relay h245-alphanumeric
!
dial-peer voice 222 voip
no vad
dtmf-relay h245-alphanumeric
!
dial-peer voice 1000 voip
destination-pattern T
session target ras
no vad
dtmf-relay h245-alphanumeric
!
!
!
!
!
!
! Gateway configuration.
!
gateway
h323-id 222
security password 222 hash
security clear-token-option old-style
gkip 192.168.1.3 1719 128
no ignore-msg-from-other-gk
register
!
!
! Codec classes configuration.
!
voice class codec 1
codec preference 1 g729
codec preference 2 g7231r63
codec preference 3 g7231r53
codec preference 4 g711alaw
codec preference 5 g711ulaw
!
!
!
! SIP UA configuration.
!
sip-ua
!
!
! MGCP configuration.
!
mgcp
no codec
vad
!
!
! Tones
!
!
!
!


Собственно вот при такой конфигурации шлюз поднимает трубку и выдаёт гудки что занято..
Ну там и понятно что я намутил с dial-peer но 3CX вообще нехотит соединятся вот и понять немогу в чем дело.. и как говориться что на так сделал.

3CX стала поддерживать H.323? Вы, как я вижу, пытаетесь "подружить" их именно по H.323.

В общем заработало!

Забыл сказать что сервер 3CX 192.168.1.3 AP200D 192.168.1.7

!
version 8.30U
!
hostname AP200D
!
!
no bridge spanning-tree
!
dhcp-list 0 type server
dhcp-list 0 address server interface ether0.0
dhcp-list 0 option dhcp-lease-time 7200
!
dhcp-list 1 type server
dhcp-list 1 address server 10.1.1.2 10.1.1.254 255.255.255.0
dhcp-list 1 option dhcp-lease-time 600
!
!
ip-share enable
ip-share interface net-side ether0.0
ip-share interface local-side ether1.0
!
interface ether0.0
ip address 192.168.1.7 255.255.255.0
!
interface ether1.0
no ip address
ip dhcp-group 0
!
snmp name AP200D
!
no arp reset
!
route 0.0.0.0 0.0.0.0 192.168.1.1
!
dnshost domain AP200D
dnshost nameserver 192.168.1.1
!
service ez-setup
!
auto-script autorun.inf
!
!
!
!
!
! VoIP configuration.
!
!
! Voice service voip configuration.
!
voice service voip
fax protocol t38 redundancy 0
fax rate 9600
h323 call start fast
h323 call tunnel enable
busyout monitor gatekeeper
busyout monitor voip-interface
!
!
! Voice port configuration.
!
! FXO
voice-port 0/0
connection plar 10000
ring detect-timeout 50
no comfort-noise
busyout action port-down
caller-id enable
caller-id type etsi
caller-id name disable
!
!
! FXO
voice-port 0/1
no caller-id enable
!
!
!
!
! Pots peer configuration.
!
dial-peer voice 1 pots
destination-pattern T
port 0/0
user-name 10000
user-password 10000
!
!
!
! Voip peer configuration.
!
dial-peer voice 3 voip
destination-pattern T
session target 192.168.1.3
session protocol sip
codec g711alaw
no vad
dtmf-relay h245-alphanumeric
fax protocol t38 redundancy 0
fax rate 9600
!
!
!
!
!
!
! Gateway configuration.
!
gateway
h323-id voip.192.168.1.7
no ignore-msg-from-other-gk
!
!
! Codec classes configuration.
!
voice class codec 1
codec preference 1 g711alaw
codec preference 2 g711ulaw
codec preference 3 g729
codec preference 4 g7231r63
codec preference 5 g726r32
!
!
!
! SIP UA configuration.
!
sip-ua
!
!
! MGCP configuration.
!
mgcp
no codec
vad
!
!
! Tones
!

Единственное что нужно было сделать это зайти в настройки шлюза в 3CX в закладку дополнительно и поменять параметр В настройках регистрации "Требуется регистрация для" поменять параметр на "необязательно" а до этого стояло "Входящие и исходящие вызовы."