AddPac 1005 не определяет CallerId. Уже не знаю что делать
. Обычный телефон и шлюз dlink 7111s определяют номер на этой линии.Настройка порта:
voice-port 0/0
connection plar 301
ring number 3
ring detect-timeout 70
caller-id enable
caller-id type etsi
Лог deb voip call и deb rta ipc:
[8733.145] VM(0/0/0) Rx FXO Ring Actv
[8733.145] VM(0/0/0) Tx RING_IND
1 <CEP 000000> : Call Received
[8734.285] VM(0/0/0) Rx FXO Ring Idle
[8734.285] VM(0/0/0) vopp enable
[8734.285] VM(0/0/0) play mute
[8735.425] VM(0/0/0) Rx FXO Ring Actv
[8735.425] VM(0/0/0) vopp idle
[8735.425] VM(0/0/0) FXO OnHook
[8735.425] VM(0/0/0) Tx OFFHOOK_IND
2 <CEP 000000> : Call Initiated : calledNumber() crv(0) total(0)
3 <Call 2> : ****************** Call Created status(InitiatedByFXO
) *******************
4 <CEP 000000> : Decode CID :
5 <CEP 000000> : Calling number()
6 <CEP 000000> : Call id(a4960c4f-ab49-1585-8004-0002a40861ac) callNum(
2)
7 <Call 2> : MatchAllProcess After Sorted
<0> id(0) dest(T) prefer(0) selected(1)
8 <Call 2> : Initiate callee with dial-peer(T) status(CalleeDetermi
nedAll) id(a4960c4f-ab49-1585-8004-0002a40861ac)
9 <NetEP 2> : InitiateOutCall: calledNum(301) callingNum() target(19
2.168.0.116)
10 <NetEP 2> : DoCall: calledAddr(sip:301@192.168.0.116) callingAddr(
)
[8735.430] VM(0/0/0) set T38 mode STD
[8735.430] VM(0/0/0) Fax rate 9600
11 <SIP 0> : No authentication information available
12 <SIP 2> : Send INVITE Request
[8735.475] RTA(0/0/0) Rx RS_LISTEN_REQ callId=2 ssId=1 G711U
peer=0.0.0.0 mp=23004/23005 hp=0/0
13 <SIP 2> : Receive 100 Trying
14 <SIP 2> : Transaction (2 INVITE) proceeding
15 <SIP 2> : Receive 200 OK
16 <SIP 2> : Get SIP Audio MediaFormat : 8
17 <SIP 2> : SetRemoteSocketInfo : ip(192.168.0.116) port(16820)
[8735.585] RTA(0/0/0) Rx RS_OPEN_REQ callId=2 ssId=1 G711A
peer=192.168.0.116 mp=23004/23005 hp=16820/16821
[8735.585] RTA(0/0/0) Rx AP_SVC_REQ nSvcElem=1 rawDataLen=0
DTMF_CTRL 1
[8735.585] VM(0/0/0) DTMF_RTP_RFC2833 enable
[8735.585] VM(0/0/0) DTMF_RTP_RFC2833 TxPT=0x65, RxPT=0x65
18 <Call 2> : Connected from(fffffffe)
[8735.585] RTA(0/0/0) Rx AP_SVC_REQ nSvcElem=1 rawDataLen=0
VAD_CTRL 0
[8735.585] VM(0/0/0) VAD disable
[8735.585] VM(0/0/0) SID enable by CCC
[8735.585] RTA(0/0/0) Rx CC_CONNECT_RSP peerId(0/0/0)
[8735.585] VM(0/0/0) FXO OffHook
[8735.585] VM(0/0/0) vopp enable
[8735.585] VM(0/0/0) Fax enable
[8735.585] VM(0/0/0) play mute
19 <NetEP 2> : Call with sip:301@192.168.0.116 established
20 <SIP 2> : Received INVITE OK response
21 <SIP 2> : Send ACK Request
22 <SIP 2> : Check Event Relation
23 <SIP 2> : Set Terminated Success for 2 INVITE
[8735.615] VM(0/0/0) codec same G711A
[8735.615] VM(0/0/0) Rx RTP replace codec to G711A
[8735.735] VM(0/0/0) Rx FXO Ring Idle
[8743.350] VM(0/0/0) listen LineBusy tone
[8743.350] VM(0/0/0) vopp idle
[8743.350] VM(0/0/0) FXO OnHook
[8743.350] VM(0/0/0) Tx DISCONN_CNF
24 <CEP 000000> : Disconnected(17) at Busy
25 <Call 2> : Terminated from(0) this(Local:PortBusy) before(NULL)
forced(0)
26 <CectCall at Idle
27 <SIP 2> : ReleaseWithBYE
[8743.365] VM(0/0/0) Rx FXO Ring Actv
[8743.365] VM(0/0/0) Tx RING_IND
28 <SIP 2> : Send BYE Request
[8743.370] RTA(0/0/0) Rx RS_CLOSE_REQ callId=2 ssId=1 dir=reve
[8743.370] RTA(0/0/0) Rx RS_CLOSE_REQ callId=2 ssId=1 dir=forw
[8743.370] RTA(0/0/0) close Media socket
[8743.370] RTA(0/0/0) close RTCP socket
29 <NetEP 2> : Call TO <sip:301@192.168.0.116> terminated reason(Loca
l:PortBusy)
30 <CEP 000000> : Call Received
31 <SIP 2> : Receive 200 OK
32 <SIP 2> : Transaction (3 BYE) completed
[8743.515] VM(0/0/0) Rx FXO Ring Idle
[8743.515] VM(0/0/0) Rx FXO Ring Ignore
[8743.515] VM(0/0/0) Tx DISCONN_CNF
33 <CEP 000000> : Disconnected(16) at Busy
34 <SIP 2> : Set Terminated Success for 3 BYE
Может кто сталкивался с аналогичной проблемой? Помогите пожалуйста)
Есть мысль что AddPac не успевает определить номер, т.к. при поступлении звонка он сразу берет трубку, причем нагло игнорирует параметр "ring number". Может в этом дело?